
Erittäin laadukas kuulokevahvistin jota voi käyttää myös etuasteena. Kunto on täydellinen. Ostettu 4.8.2013 (kuitti mukaan). Kyseessä on tehtaalla koottu malli eli takuu on 3 vuotta. Putkena on 6N1P.
Sijaitsee Malmilla Helsingissä.
Kauppatapa: 1. Hinta = Hintapyyntö = Osta heti -hinta. Tarjoukset ketjuun.
Hintapyyntö: 150 EUR
Yhteydenotot:
pkm808 ÄT gmail PISTE com
o5o 33o 4819
Valmistajan sivut: http://www.garage1217.com/graphic_design_004.htm
Speksit:
Specifications:
- Solid state output stage
- Non overall feedback - triode voltage gain stage
- Power consumption: 5W continuous, 15W peak
- Power supply: 48VDC (0.10A cont, 0.32A peak)
- Input Resistance: 11 kO or 21 kO depending on gain setting
- Input Sensitivity (6N23): 0.8V or 1.6V (dependent on gain setting and used tube)
- Gain: 20- 26dB (selectable and dependent on tube)
- Max Output voltage: 15.7Vrms at 300Ohm
- Output Resistance: Selectable 0.1O, 35O or 120Ohm
- Frequency Response: 3Hz – 65 KHz (-0.5dB) with 32Ohm load
- Frequency Response: 1.5Hz – 190 KHz (-3dB) with 32Ohm load
- Signal to Noise ratio: 92dBA (dependent on tube)
- Crosstalk: -89dB (dependent on tube)
- THD: > 0.010% (dependent on tube)
- Suitable for: 16-600ohm Headphones
So to summarize what Ember has to offer...
- Auto bias. Simply plug in a tube from a long list of 6 & 12V dual triodes and it will bias itself
- Bias continuously adjusts itself so ageing of a tube is constantly corrected, within limits of course
- Auto heater selection. Plug and play with a 6 or 12V tube and the heater voltage arrangement will be automatically set
- Startup protection circuit with thermal shutdown
- Advanced cooling design to keep temps nice and low
- Three output resistance settings from 0.1, 35 and 120 Ohm
- Input capacitor bypass possibility for more tuning options
- Selectable gain
- Pre-amp output so it can double as a volume controlled tube buffer
- Very efficient, low power consumption, low temperatures
- Awesome choice for headphones from 32-600 Ohm but can also drive 16 Ohm headphones
- Lots of headroom and more than enough output power up to 1.8W, depending on headphone and settings
- Comes with tube and power supply. Plug in your source to the RCA jacks, plug in your headphones and fire her up!
- Not an audiophile feature, but you can change the under tube LED color to anything that you like via the RGB LED adjustment. Correct, we do not - even force you to like the same color we do
- A tribe of beautiful virgins from the Amazon... No, you did not read that part correctly - we cancelled that option as shipping was expensive and maintance was high